Multi-output power supply design based on TOPSwitch

MOS power IC full range

KKST patch plug-in active passive crystal oscillator hot sale 24.576000MHZ

Overview:
With the continuous development of power electronics technology, the application of frequency conversion speed regulation technology in the field of industrial transmission is more and more extensive, especially the application of AC-DC-AC frequency conversion speed regulation.
The AC-DC-AC variable frequency speed control circuit includes a rectification and inverter part, wherein the inverter part is typically 6 switching units (IGBT or MOS tube), 3 upper and lower arms, and some with a braking unit of 7 Switch unit. Since the reference ground of the control trigger pulse signals of the three units of the upper arm is suspended, the trigger pulses generally need four sets of power sources that are isolated from each other (the upper arm 3 units are respectively powered, and the lower arm shares a set of power sources). Of course, if the software cooperates with the control and gives a charging pulse, the power supply of the three units of the upper arm uses a bootstrap circuit, and only one set of power supplies can be used.
Only the case of using four sets of power supplies will be discussed here. The control auxiliary power supply of the inverter has three characteristics:
1) has multiple output voltages. The power supply described in this article has 5V, ±15V, four 16V trigger pulse power supplies, 12V bias power supply, and 24V total 9 output voltages. Among them, the 5V, ±15V output voltage is common, and the remaining output voltages are independent output voltages;
2) Four sets of pulse power supplies require better output voltage consistency and higher voltage regulation accuracy;
3) Four sets of pulsed power supplies are required to provide large instantaneous power, but the average power is small.
To meet the above requirements, it is simple and low-cost. It is a good choice to use the TOPSwitch series of American PI companies. TOPSwitch series products integrate MOS tube and PWM controller in one chip. The peripheral circuit is very simple. The power range covers several watts to hundreds of watts. The chip package is available in various forms. Some chips also have over-temperature and over-current. And input voltage overvoltage, undervoltage and other protection functions, can flexibly adapt to the design of many power supplies. PI also introduced auxiliary design software for the TOPSwitch family of products to allow users to quickly and accurately design the required power supply. When I was working on a servo controller project, the auxiliary power supply was designed with TOPSwitch products. As a typical example, the design method and key points are briefly introduced below.
(Please read the PDF for details)